SpunkArt
Home and local services · Phoenix

Choosing an HVAC contractor for a new AC in Phoenix

Replacing an air conditioner is one of the largest home purchases in a desert city. The contractor matters as much as the equipment, because a well-made unit that is sized or installed badly still performs badly. This guide shows how to judge the bids.

Please note: This page is general information only. Check the details for your own situation before you rely on it.

Don’t buy under pressure

Phoenix summers are long and very hot, and many replacements happen in a rush when an old unit dies in July. If your system is old and needs frequent repairs, start collecting bids in the cooler months. You get more time with each contractor and you can compare calmly.

If the system fails in extreme heat and someone in the home is vulnerable to heat, protect people first: move to a cooled space, and call 911 if anyone shows signs of heat illness.

Tons and BTU, briefly

Air conditioner capacity is sold in tons. One ton of cooling equals 12,000 BTU per hour, a measure of how much heat the system removes.

BTU per hour = tons × 12,000

Example. A 3.5-ton system removes 3.5 × 12,000 = 42,000 BTU per hour at its rated conditions.

Bigger is not better. An oversized unit cools the air quickly, shuts off, and starts again often. That short cycling can leave rooms uneven and wear parts faster. An undersized unit runs constantly and still falls behind on the hottest afternoons.

Ask for a load calculation

The industry method for sizing is a room-by-room heat load calculation, often called a Manual J calculation after the standard published by the Air Conditioning Contractors of America. It considers floor area, insulation, windows, which way the windows face, air leaks and local design temperatures.

A contractor who sizes the new unit only by matching the old one, or by a quick rule of thumb per square foot, is guessing. Ask each bidder: “Will you do a load calculation, and will I get a copy?”

Compare bids line by line

Line on the bidWhat to look for
EquipmentModel numbers for the outdoor unit, indoor coil and furnace or air handler, so you can confirm they are a matched set
Efficiency ratingThe SEER2 rating of the matched system
DuctworkWhether ducts are tested, sealed, repaired or replaced
PermitWho pulls the permit and arranges the inspection
ThermostatIncluded or not, and which type
WarrantyParts warranty from the maker and a separate labour warranty from the contractor
RemovalRemoval of the old unit and proper recovery of its refrigerant

Questions to ask every contractor

  1. Are you licensed for HVAC work in Arizona? (Check the number with the state licensing agency.)
  2. Will you test my ducts for leaks? Leaky ducts in a hot attic waste cooling.
  3. How will the outdoor unit be placed for shade and airflow?
  4. Who will install it: your own technicians or a subcontractor?
  5. What maintenance do you recommend in the first year?

Common mistakes

  • Comparing bids on price alone without matching the equipment and scope.
  • Replacing the outdoor unit only and keeping an old, mismatched indoor coil.
  • Ignoring the ductwork, which can undo the gains of a new unit.
  • Signing a financing offer on the spot without reading the rate and terms.

FAQ

Is a higher efficiency rating always worth it?

It depends on how many hours the system runs and your electricity rate. In a hot climate with long cooling seasons, higher efficiency pays back faster. Ask the contractor to show the estimate behind any savings claim.

How many bids should I get?

Three is a good number. It is enough to see whether one bid is far out of line.