SpunkArt
Home and local services · Las Vegas

Yard care and irrigation in Las Vegas’ dry climate

In the desert, water is the main cost and the main limit of any yard. Before you hire a landscaper or an irrigation technician, it helps to know how much water your yard actually gets. This guide shows a simple test and the maths behind it.

Please note: This page is general information only. Check the details for your own situation before you rely on it.

Start with the rules where you live

Water agencies in the Las Vegas valley set watering schedules and rules about grass. These rules change, so read the current schedule from your water provider before you plan any planting or hire any work. Ask any landscaper you hire whether they know the current rules, and whether their plan follows them.

The catch-cup test

A sprinkler’s precipitation rate is how many inches of water it puts down in an hour. You can measure it yourself with a few straight-sided cups or tins.

  1. Place six or more identical cups in a grid across one zone.
  2. Run that zone for exactly 15 minutes.
  3. Measure the water depth in each cup with a ruler.
  4. Average the depths.
  5. Multiply the average by 4 to get inches per hour.
precipitation rate (in/hr) = average depth (in) × 60 ÷ minutes run

Example. The cups average 0.375 inches after 15 minutes. Rate = 0.375 × 60 ÷ 15 = 1.5 inches per hour. To apply half an inch of water, run the zone for 0.5 ÷ 1.5 × 60 = 20 minutes.

The test also shows uneven coverage. If one cup holds twice as much as another, a head is blocked, tilted or the wrong nozzle. That is a specific fault you can ask a technician to fix.

From inches to gallons

One inch of water over one square foot is about 0.623 gallons. This lets you turn a watering depth into a volume.

gallons = area (sq ft) × depth (in) × 0.623

Example. A 1,000 sq ft patch of grass watered to half an inch uses 1,000 × 0.5 × 0.623 = about 312 gallons each time (rounded to the nearest gallon).

Multiply by the number of watering days in your schedule to see what the grass costs in water. Many owners in dry climates use numbers like these when they decide whether to replace grass with desert plants on drip irrigation.

Spray versus drip

FeatureSpray headsDrip emitters
Best forGrassShrubs, trees, beds
Loss to wind and evaporationHigherLower, because water goes to the root zone
Common faultsOverspray onto paving, broken headsClogged emitters, chewed or cracked tubing
How to checkRun each zone and watchLook for wet spots and dry plants

Questions for a landscaper or irrigation tech

  • Will you test each zone and show me the faults you find?
  • How will you set run times for summer and for winter?
  • Which plants in your design need the least water once established?
  • Do you add a pressure regulator and filter to drip lines?
  • Will you show me how to change the controller schedule myself?

Common mistakes

  • Watering at midday, when more water evaporates.
  • One long run on hard soil, so water runs off. Split it into shorter cycles.
  • Leaving the summer schedule running all winter.

FAQ

Why multiply by 0.623?

A cubic foot holds about 7.48 gallons. One inch is one twelfth of a foot, so one inch over one square foot is 7.48 ÷ 12, about 0.623 gallons.

Can I do the catch-cup test on drip lines?

No. Drip is measured in gallons per hour per emitter. Check the emitter ratings and count the emitters on each plant instead.