SpunkArt
Home and local services · Minneapolis

Getting your furnace ready for a Minneapolis winter

A furnace that fails in a Minneapolis January is more than an inconvenience. Booking a check in early autumn, before the first cold spell, is easier and calmer than an emergency call. This guide covers the home checks and the questions to ask a technician.

Please note: This page is general information only. Check the details for your own situation before you rely on it.

Safety first: carbon monoxide

A gas or oil furnace burns fuel. If the burner or the vent fails, it can release carbon monoxide (CO), a gas you cannot see or smell. Put a CO alarm on every level of the home and near sleeping areas. Test them when you change the clocks. If a CO alarm sounds, get everyone outside and call 911 or your gas utility from outside.

Checks you can do yourself

  1. Replace the filter. Note the size on the frame and the arrow showing airflow direction.
  2. Clear the area around the furnace. Do not store paint, solvents or boxes beside it.
  3. Check outside vents. High-efficiency furnaces often vent through plastic pipes in a side wall. Keep snow and ice clear of them all winter.
  4. Test the thermostat. Switch to heat, raise the setting and listen for the furnace to start.
  5. Look at the flame, if your model has a viewing window. A steady blue flame is normal. A yellow, lazy flame is a reason to call a technician.

What a heating tune-up should cover

  • Inspecting the heat exchanger for cracks.
  • Checking the burners, igniter and flame sensor.
  • Testing safety switches and limit controls.
  • Checking the vent and chimney connection for blockage or leaks.
  • Measuring CO in the flue gas and near the appliance.
  • Checking the blower motor and belt, if there is one.
  • Draining and checking the condensate line on a high-efficiency unit.

Ask for a written report. If the technician says the heat exchanger is cracked, ask to see the crack or a photo of it, and consider a second opinion before replacing the whole furnace.

AFUE: what the efficiency number means

Furnaces are rated by AFUE, Annual Fuel Utilization Efficiency. It is the share of the fuel’s energy that becomes heat in your home over a typical year.

heat delivered = fuel input × AFUE

Example. A furnace with an input of 100,000 BTU per hour:

  • At 80% AFUE: 100,000 × 0.80 = 80,000 BTU per hour of heat
  • At 96% AFUE: 100,000 × 0.96 = 96,000 BTU per hour of heat

The second furnace delivers 16,000 more BTU per hour from the same fuel. In a long, cold winter, that difference adds up.

Repair or replace?

Lean toward repairLean toward replace
A single part such as an igniter or flame sensor has failedThe heat exchanger is cracked
The furnace is fairly newRepairs are frequent and the furnace is old
Rooms heat evenlyRooms heat unevenly even after duct checks

If you replace, ask for a heat load calculation for your house rather than a size based on the old unit. Homes change over time with new windows and insulation.

FAQ

When should I book a tune-up?

Early autumn, before the first cold weeks. Technicians are busiest once nights turn cold.

What if the furnace stops on a very cold night?

Check the thermostat, the breaker, the filter and the outside vent for snow. If it still does not run, call for emergency service and protect pipes from freezing.